Scrad is correct,
AS an SP fan and owner of a GT series ESC, the ability to update and change the software to BLINKY can be done.
The current Reventon Prog. box CAN'T be used to update the firmware/software, however the older programmer or similar (such as the HW box below) CAN be updated.
http://www.hobbywing.com/product_show.asp?id=288
I've done it to my GT ESC, and its not difficult, but it IS a process.
Sounds like THIS is the ESC you have:
http://www.speedpassion.net/en/produ...802PROcb&c=ESC
(It should have the necessary links for the software Etc that you will need.)
-You will First need to download the Software for the ESC
-Next, you will follow the steps for updating the device firmware.
*You will format and replace the stock HW (or whatever prog. box you buy, since so many companies use the same box, but load diff. firmware)
-The instructions will tell you how to update the device (prog box) firmware to the latest, (for example HW Version.: 1.846367etc WITH SP version 1.984645 etc.)
-The Firmware for the device with update and when its turned Off and on, instead of HW it should indicate SP.
*All this is done even before you attach the ESC.*
Once the firmware is set to SP, you should then be able to connect the ESC and change the software (Profiles) from Default to STOCK0 which I believe is the Blinky mode.
Hope this helps point you in the right direction
MOmo