R/C Tech Forums - View Single Post - TLR 22 3.0 Race Kit Thread!
Thread: TLR 22 3.0 Race Kit Thread!
View Single Post
Old 02-05-2016, 11:36 AM
  #1914  
goehm
Tech Elite
iTrader: (45)
 
goehm's Avatar
 
Join Date: May 2010
Location: Northern VA
Posts: 2,765
Trader Rating: 45 (100%+)
Default
Originally Posted by RC10Nick
The chassis stiffener is actually two pieces, an upper and a lower layer. The servo mounts only rest on the lower stiffener so I needed extra screws in that area to clamp the top stiffener down to the chassis. My original design did not have these screws and had a severe amount of flex as a result. I could probably get rid of one of the screws up front, but I feel more confident in the design having it there.
Hey Nick, once you migrate to CF you can probably do away with the screws to combine the plates and use a high tensile strength epoxy geared for CF use. Something like this is what I was looking at for some of my stuff (50ml part a and b is probably plenty):
http://www.golfworks.com/product.asp...EPX1_A_cn_E_33

Super glue would probably break apart over time due to chassis flex and lose it's tensile strength.

Cool project!
goehm is offline  
Reply