R/C Tech Forums - View Single Post - Serpent Natrix 748e
Thread: Serpent Natrix 748e
View Single Post
Old 01-24-2016 | 08:28 PM
  #31  
performula
Tech Master
iTrader: (4)
 
Joined: Jan 2003
Posts: 1,955
Default
Originally Posted by dan_vector
It comes with a 48dp/75t spur which is the same fitment/type as the 411.

The internal ratio is the same as the 747e so you can use this calculator on the serpent site.

http://www.serpent.com/file.php?FileID=5916
I went ahead and picked one up. Something I cannot resist about this car. I guess my next will be a 1/8 scale and I'll probably be done.

I picked up some Contact RC foams and a Team Powers Actinium 4.5T motor - it was only 700kV under the next highest but about a third to half the cost. I'll be running my Brushless Hobbies 120A ESC in this car as well. A couple 3300 packs, a couple 4400 packs, and a couple 5500 packs.

How long should these packs last if I'm just tooling around the culdesac/speed runs? It's a shame I cannot race it at least not yet. Maybe it will take off if I practice with it at the track.
performula is offline  
Reply