Originally Posted by
intensemojo
Blew through two Hitec servos this week. Luckily both are covered by warranty. Moving on to a Futaba 9352.
My question is related to the servo saver. I've got three turns out as a the manual describes, are you guys doing anything different?
I run my servo saver 1/2 turn from tight. I had a centering issue and was corrected with it tighter. It did it on both my eb and sct. If you trashed 2 servo's, 1. make sure the steering link is level if not using a tekno servo horn. 2. check your end points. if they are set too far it will trash them as well. I am now using the screw stops to make sure they don't go too far. I am running the 7955 and have ran the 1256 both with no issues.