Originally Posted by
jakeb
Hey All,
New to the Xray platform as I will be receiving an new XB4 in the next few days.
Looking through the manual I notice that there aren't any shock shaft measurements or free length measurements to get baseline droop setup, aside from the number of shims under the piston.
How are you all doing it? Are you just setting shock shaft length to one consistent measurement or are you using some form of droop measurement during final setup?
Thanks a bunch.
- Jake
Easy…..you build the shocks with the shock rod ends screwed on with no visible threads showing on the shock shaft.
Droop is then adjusted with shims inside shocks or if more droop is needed by unscrewing the shock rod ends 2-3 full turns.
Bent