R/C Tech Forums - View Single Post - Tune With Camber Links
View Single Post
Old 01-08-2016 | 01:40 AM
  #2091  
micholix
Tech Addict
 
Joined: Jun 2012
Posts: 623
From: Austria
Default

Hi all,

I do have a question, i have done the balance test and set up on my new wheeler and ended up with the hadest rear and the softest front springs from the set, to get the right spring balance.
Anyway, after that i balanced oil and pistons and it went well, but the car packs a bit to early, so my question is, should i lower oils, change pistons to bigger hole size, or can i just move the shocks to the inner hole on the arms, to get the pack a little bit later, without changing the other factors?

So here's, what i'm at the moment.

Rear end:
Shocks middle on tower and arm
3x1.6 mm pistons
35wt oil

Front end:
Shocks middle on tower and arm
3x1.5 mm pistons
30wt oil

May i have to drop oil anyways, as temps in europe are very low atm!?


Your help would be much appreciated.

Thx in advance and

Last edited by micholix; 01-08-2016 at 02:24 AM.
micholix is offline