R/C Tech Forums - View Single Post - Can I replace a crankcase without replacing the crankshaft too?
Thread: Can I replace a crankcase without replacing the crankshaft too?
View Single Post
Old 01-03-2016 | 02:15 PM
  #22  
blis's Avatar
blis
Tech Elite
 
Joined: May 2008
Posts: 3,478
From: Brisbane
Default
Originally Posted by fyrstormer
I'm honestly not sure the Hudy bearing puller would work for my engine. The .08 crankshaft is much narrower than a .12 crankshaft is.

This video sure makes it look easy. It was never that easy for me, not with a Picco engine anyway:

+ YouTube Video
ERROR: If you can see this, then YouTube is down or you don't have Flash installed.
You may be right. What diameter is the crank on the .09 ?
blis is offline  
Reply