Originally Posted by
nitro2be
Simple question, adding shims under rear hanger/bumper will decrease anti squat? No shims anywhere just bumper =2 degree. Right?
Ok. You asked for it...
#1.
The manual calls for 1mm worth of shim either on top of or below the rear hinge pin holder, OR, 0.5mm in each spot.
This keeps the distance from the chassis to the transmission mount at the stack up dimension it was designed to have.
My measurements are as follow.
No shim under the rear hinge pin mount = 2.225 degrees
0.5mm under = 1.484 degrees
1mm under = 0.742 degrees
Here's my math.
Any input is welcome.
