Finally got around to make the front camber arms on my M03. Basically took the same idea I did on the M-Four. Two short ball connectors chopped off about 1mm each, 8mm set screw inside. Used a few bushings to position the arms properly on the M03.

Car is dialed with -1 camber, not the ridiculous amount it came with out of the box. At least on my track no need for that much camber; not only did it not have the stability I wanted, it also ate the tires too fast on the inner treads.

http://www.rctech.net/forum/members/...r-arms-top.jpg

http://www.rctech.net/forum/members/...amber-arms.jpg