View Single Post
Old 11-06-2015, 10:03 PM
 
Josh L
Tech Addict
iTrader: (1)
 
Josh L's Avatar
 
Join Date: Mar 2015
Location: Greenville VA
Posts: 685
Trader Rating: 1 (100%+)
Default

Agreed Dan. It's going to have to be impressive to get me off the HW bandwagon to.

So I got bored and was looking at that awful waste of a rear servo tray and made a nifty TB wrench holder out of it. Just drill yourself a hole big enough to fit one of the prongs on the wrench and run a servo holder screw in the other corner. I will eventually replace the servo screw with a stud and a small wingnut to make it easier to get on and off without needing a hex.
I guess it does ad some weight, but I doubt it's enough to cry about. No more misplaced wrenches this way!

Josh L is offline  
Reply With Quote