Originally Posted by
3D-Seth
I'm running white belts. I installed the black belts first for reference, then the whites. Whites feel a little looser than the blacks with the diffs in the same positions. I had some slippage with the front white belt after a couple packs, so tightened it one notch from center. Rear belt is in the center (down) position still. No issues here so far. I'm running 13.5 blinky at my track, so can probably run my belts a little looser than the mod guys. Racing this weekend, so going to try running the rear a notch looser if I can. I'll report back if any issues.
Seth
The white belts are softer than the black stock belts and get loose after break in. Perhaps this was a one off thing, could be also due to some stone chip. I have installed a black belt once more. Will update you if I experience this issue again. I will leave it slightly loose not to have any binding. Thanks for your feedback.