Ive checked cables ,motors ,not 100% sure on settings .
my motor is censored and cable plugged in .
If i move the wheels the motor will spin thus making clunky feel and takes a while to get the speed to full .
Motors are 100% fine.ive got steering .checked solder points fine.motors do get hot so does the cables .so not playing with it anymore till i can get a fix.
Turnigy Trackstar 120A Turbo Sensored Brushless 1/12th 1/10th ESC.
Setting with Program Card are: Default
Operation Mode :*2.For/rev/Brake
Initial Brake :*1. =Drag Brake
Drag Brake :*2. 5%
Brake Strength :*4.
Voltage CutOff :*3. 3.2V/cell
Punch Profile :*7. Level 7
Neutral DeadBand :*2. 3%
Boost Timing : *1. 0deg
Turbo Slope :*4. 18deg/0.1s
Turbo Timing :*1. 0deg
Boost Timing RPM :*5. 4000
Turbo Delay :*3. 0.1sec
Boost Timing ACC :*2. 100RPM/deg
Reverse Speed :*3. 75%
Drive Frequency :*1. 8KHZ
Brake Frequency : *1. 1KHZ
Temperature Set : *1. On
Restore Default : *1. No
I must ask does this ESC only work with a Turbo Motor ? or censored motors (with in limits of ESC.) as the motors ive been trying to use are not Turbo.and are well under amp=70-90max .thanks guys.
