Originally Posted by
3D-Seth
Same as above. I had two screws messed up as well.
Also had tight arms, needed to do a light sanding (1200grit) then polish with mothers to get them to move free (but without slop). Polish first, if they're still tight, then try something like 2000 grit or 1500, re-polish and try again. Don't want them sloppy loose, but need to be free.
Seth
Are you sure that;
A. you had the pivot block holders the correct way around, as the chamfer for the inserts is deeper on one side.
B. The block holders were tightened down 'correctly', i.e. I had to hold the individual holders at the back with a pair of pliers to stop them rotating whilst being tightened down.
I only ask as I don't know of anyone ever having to sand the wishbones. If they've been tight, there has always been a reason other than the width of the wishbones.
Skiddins