R/C Tech Forums - View Single Post - Street Jam SJF01 Formula 1. Niiiiiiiiice!

10-23-2015, 05:51 AM

#435

fmm

Tech Adept

Join Date: Nov 2013

Posts: 105

Trader Rating: 0

Quote:

Originally Posted by CFRacing

We run 4.5mm ride height,for that I use 2.5mm above the upright (which controls ride height) and 3mm below the upright (which controls droop).
That plus the lower arms mounted as per instructions on the car, except do not
Put the 1mm shims' between the chassis and suspension plate. I think that's about it. Hope that helps .

Thank you very much!
What tamiya pins are you using? I using tamiya 54160 and I use 3mm under the uprigth, but I need to add 6mm above the uprigth. Am I doing something wrong? Or is it because you add 3.5 mm above the exotek arms to compete the length of the pin?

Thanks a lot

Reply