Ok..The steering problem. Its the steering linkage from the servo all the way along to the left and right movement. Not the wheels. They appear fine.
It bangs off there sway bar kit on the figure of 8 plastic ends. Then it also moves the servo that rubs on there Esc as its very close to it.
I also noticed that the steering needs the end points on the controller adjusting. Any idea how to do that. Its putting far to much unnecessary force on there servo. A possible answer is adjust the St Rate dial on the controller, but not sure what this is exactly for.
Also any one have any idea on how to control or adjust the AVC? Not sure how to do it.
As you all known guys the instructions for this model are very poor so any advice or tips on set up, tweaks or anything else would bet greatly appreciated.
Hope all this makes sense.