R/C Tech Forums - View Single Post - Yokomo YZ-2
Thread: Yokomo YZ-2
View Single Post
Old 10-12-2015, 06:36 AM
  #1518  
WillS
Tech Master
iTrader: (32)
 
WillS's Avatar
 
Join Date: Aug 2001
Location: Sacramento, CA
Posts: 1,250
Trader Rating: 32 (100%+)
Default
Originally Posted by hacker
what were you smoking when you measured em?

I got 1.5mm on each arm, so 3mm in total track width increase.

I should have taken a pic when I was doing the conversion, as I didn't quite believe it too.
When you use the 5mm hexes (as that is recommended) its only .5mm per side. If you use the 6mm hexes yes it would be 1.5mm per side.
WillS is offline  
Reply