R/C Tech Forums - View Single Post - 1/12 forum
Thread: 1/12 forum
View Single Post
Old 10-12-2015 | 05:18 AM
  #43384  
Fredp1's Avatar
Fredp1
Tech Regular
iTrader: (11)
 
Joined: Mar 2013
Posts: 393
From: Sydney, Australia
Default
Building my first 1/12, AE 12R5.2
Noticed the front upper ball pivots are tight, however the lower ball pivots are nice and free.

Should the upper ball pivots be free too? Other than using a 5.8mm ball reamer, what can be done to free them up?

Thanks
Fredp1 is offline  
Reply