Hello,
Received my exo6 kit, very nice kit! Finish and fittings are great.
Anyway, noticed 3 points that surprised me:
- An additional 6x10x3 bearing is needed for rear diff, maybe I missed that, but I didn't see it written down...
- I noticed that Exo6 upper deck diff holes pitch is a bit smaller than tamiya one (check pic attached, about 1.75mm)?? shorter lower deck ? Didn't' check that... I don't care, it can be installed without stressing the chassis, so no problem with that!
- Cannot fit tamiya 66T spur gear as gear is slightly hitting lower deck slot (gear not centred with the slot)- not no go for this point - but major point is that I cannot install upper deck due to gear diameter..... running 6.5T motor so don't need smaller spur gear
... Will have to machine one deck myself...
Once the upper deck point fixed, let's try it.
Cheers