R/C Tech Forums - View Single Post - Awesomatix EP Touring Car (A700 Shaft Drive)
Thread: Awesomatix EP Touring Car (A700 Shaft Drive)
View Single Post
Old 09-18-2015, 05:58 AM
  #8789  
Schwarta
Tech Regular
iTrader: (4)
 
Schwarta's Avatar
 
Join Date: Jun 2014
Location: Brisbane
Posts: 436
Trader Rating: 4 (100%+)
Default
Originally Posted by geeunit1014
Front bulkhead is +1mm, rear is +2mm. You will need to add 2mm to the shims that connect the motor mount to the rear bulkhead to keep the motor mount in the correct spot.
pic of ffg setup
Going to try this setup tomorrow. Do you need to make sure the screws in the top deck go through to the FFG rod slightly, to hold it in place?
Schwarta is offline  
Reply