R/C Tech Forums - View Single Post - How do you remove Crescent Rings?
View Single Post
Old 09-11-2015, 06:07 PM
  #6  
nwagner
Tech Regular
iTrader: (6)
 
Join Date: Feb 2014
Posts: 462
Trader Rating: 6 (100%+)
Default

I usually use two separate pieces, the trusty needlenose and an allen driver. Hold the needlenose on the shaft, against one tip of the clip, and push off on the other tip with the driver until it gets out of the groove and the tips are against the pin/shaft. Usually gets it started enough to get my needle nose to grip the other side to pull off and it won't go flying that way.
nwagner is offline