Originally Posted by
howardcano
I learned the hard way, when I was trying to shave some weight in my 1/12 scale. I ended up with a couple of micro servos that work great, but have these skinny little output shafts that only fit the horns that came with the servo.
There was a post just a little while ago in the 1/12 scale thread that showed the Savox 1250 with a servo saver on it, so it seems your recommendation was good!
I see. Actually I didn't recommend the 1250, it was disaac.
I personally don't run micro servo's on my cars as weight is not that critical.
I do feel that my M03 would benefit though if I run even less weight than the low profile Savox I installed on there a few weeks ago.
Thing is so top heavy.