Originally Posted by
changkh
hi i have a question. based on the manual, the recommended servo size is
width: < 20.5mm length: 38 - 41mm height: 12 - 16mm + < 30mm
will a 40.5×26×21mm servo fit. only the width is longer by 0.5 mm
Hi changkh. I didn't check or follow the manuals when I installed mine, so I have no idea if mine suits the requirements or not.
The servo is installed on its side (it's biggest flat surface to the chassis, see photo here:
),
so width shouldn't be a problem.
The servo I use is a Futaba S3003.