R/C Tech Forums - View Single Post - Team Associated TC6.2 Touring Car
Thread: Team Associated TC6.2 Touring Car
View Single Post
Old 08-13-2015, 01:19 AM
  #2196  
bertottius
Tech Master
iTrader: (28)
 
bertottius's Avatar
 
Join Date: Feb 2012
Location: Barrington, NJ
Posts: 1,509
Trader Rating: 28 (100%+)
Default
Originally Posted by rc pete
When using the TC5 rear hubs on this setup, here are two options on how to make them work on the 6.2:

1. Use the full TC5 hardware: 6x10x3 bearings, crush tubes and driveshafts. Works great, except this bearing size is not as durable. The ceramics are a must and last much longer.

2. Use 5x10x3 bearings (not 5x10x4) with the 6.2 drive shafts and no crush tubes. You might be able find or make a set of crush tubes that work or just run it without.

Does anyone have this info for the yokomo hubs, how to make them fit?
BD7 hubs use the same bearings as the TC6.2 but you have to drill out for the Associated pin and use a couple of shims to center it in the TC4 arm.

Hope that helps.
bertottius is offline  
Reply