Originally Posted by
bjames
Anyone have a flying fox layshaft they would be willing to sell? I'll pay top $ for it. Thanks!
They are extinct. BUT, if you were looking for one to fit a wider LiPo than is normal you can still use these:
https://www.tqrcracing.com/shop/prod....asp?p_id=5250
That is a 3-racing center pulley which is the correct pitch, tooth number, internal diameter, and it is set with a set-screw. Just ditch the non-spur side pulley, space the pulleys out, grind a flat spot in your drive shaft and you're good to go.
It should look something like this:
http://www.rctech.net/forum/attachme...y-img_3544.jpg
Big shout out to RCTech's masterhit for the method.
If you wanted to be able to run new spur gears, forget about it. All of the adapters are gone and with a stock 118 tooth spur you can gear to 3.85:1 anyway, plenty to race 17.5.