View Single Post
Old 06-16-2015, 06:30 AM   #821
worm304
Tech Adept
 
Join Date: Sep 2014
Posts: 149
Trader Rating: 1 (100%+)
Default

Quote:
Originally Posted by Dont Hack Me View Post
Did you try a small shim, One side at a time? Might help. Then again if its a really small spot like you said, might just need to spin it a little and break it in. When I do ring and pinions. I'll build them, spin them and listen to the sound, See how they feel, is it mostly smooth or can i feel every single tooth, I also will flip my front/rear clip over and mash my thumb onto the ring gear and diff case so the ring gear cant move at all and check the backlash to the pinion. You really want it as tight as you can get it WITHOUT binding at all. You don't want to feel the teeth as you spin it by hand. You going to feel the teeth engaging, you just don't want a chunk, chunk, chunk. As you spin it. Please add grease
I tried to shim both sides to see what would happen and it was worse so I just shimmed the opposite side of the ring gear and it's smooth.. Added some grease and now I can continue. Thanks!
worm304 is offline   Reply With Quote