M2C RACING IS PLEASED TO ANNOUNCE THE RELEASE OF THE
NB48 GAS CHASSIS

These chassis are made using 4 MM thick 7075 aircraft grade materials and clear anodized.

use of this material greatly increases the overall life of the chassis.

we have tested and tweeked these chassis to provide the racers a top notch chassis that will perform very well on all surfaces.

This model is made for the tracks with a high wear charastic like the tracks we have out West,up north and in Canada

It is important to note that these skid plates fit flush to the bottom of the chassis and will not effect the droop settings and cause you to

scrub speed on the landings.

FEATURES:

We have made the diff cutout thru and added material back to this area of the chassis to stiffen up this area. This should help decrease the possibility of broken spur gears due to chassis flex.

We have also reworked the motor area to and deleted the stock motor mount and replaced it with a rock solid 3 pc quick change mount design that we have using on the mugen for years. we have also pocketed the motor mount area 1 mm deep.



this along with the mugen mount being 1/2 mm shorter than the stock mount lowers the CG of the motor by 1.5 mm.

An added benefit of the is that now you can now use about any starter box on the market desiged for 1/8 scale cars.

PLEASE NOTE:

You will no longer have the rear motor mount or reverse diff option with this chassis.

We talked to a number of drivers and no one uses the rear mount option.



We have adopted this model so that if you wish you can cut off the front bumper to help the vehicle not to get upset on landings

and increse ground clearance.

hardened front and rear replacable skid plate.

It is advised you replace the skid plate when the edge of the skid plate wears down to 1 mm.

This will make the chassis last much longer.

hardened droop stops to prevent chassis wear and droop changes.

INCLUDED IN KIT:

skid plates:

m2c 6501 (front and rear skid plate)

m2c 6502 (front rear skid plate)

motor mount: m2c 5230

OPTIONAL PARTS:

m2c 5231 top rails for quick change motor mount.

m2c 6100 4 shoe variable weight clutch kit:

this kit will work with the stock clutch bell and the shoes last 1.5 to 3 gallons.

PLEASE ALLOW 2 TO 3 WEEKS DELIVERY TIME