So last night my LM's (TS020) rear end broke. Top motor bracket and the damper arm bracket that holds the 2 discs and springs cracked and separated into pieces. I just super glued everything together and it's running fine again, but in 5 days since ownership, both front knuckles broke, then the damper bracket and motor cover. I drive these things hard, but I was not expecting them to be so fragile.

Replacement parts ordered, also a conversion for MM. I decided to run the LP500 body instead of the BRZ after I do the conversion. Both my Sport will run wide MM.. I think the LP500 is MM...(?)

Just to temporarily check to see if I'd like a ball diff on my LM, I put Tamiya AW grease in the diff housing to slow down the action. It does run smoother and feels better coming out of the turns. The grease will start working its way out so I need to clean that out before it starts getting on my track.

Hope to have my MR03EV with TS020 body tomorrow.