View Single Post
Old 05-27-2015, 05:25 PM
  #1810  
aeRayls
Tech Elite
iTrader: (3)
 
aeRayls's Avatar
 
Join Date: Nov 2007
Posts: 2,248
Trader Rating: 3 (100%+)
Default

Originally Posted by eleine View Post
Just tried to install my new aluminum steering arms. They came with two small washers. I cant seem to get them not to bind without feeling like they are too loose and will fall out. Any tips? I tried washer on top, washer on bottom and washers on both sides of the steering arms. Have not even hooked the rack part into the arms because of the binding issue. Am I just being paranoid or has anyone else seen this?
The washers are crush tubes that go between the bearings on the plastic rack.
aeRayls is offline  
Reply With Quote