Originally Posted by
GerryH
Did you try without your servo connected (the original one)? I had a similar problem where the servo fried and when it was connected to the receiver, it would cause the ESC not to arm. Unplug the servo and it was fine.
Were all the electronics working before you started started your upgrades? And they were not part of the upgrade process?
Yes, I tried with and without the servo connected (on the first car with the original problem), and yes, it was working before we upgraded the parts (Dampers, Steering turnbuckle, front uprights) and initially seemed OK afterwards as it was running/steering on the stand.
I also tried it with a second known good receiver and have the same problem. The ESC is beeping at me the same it does when the ESC/Servo is wired incorrectly, but everything appears wired OK.