Well, plugged servo and speedo into Rx and powered it up, everything still works. Guess I need to get some shorty packs and get this thing to the track. Question on the servo horn. I mounted it perpendicular to the case, which I THINK is what's shown in pics in the manual. I'm up against the stops at full lock on both sides, no servo chatter, but it gets awfully close to the right bellcrank. One of the manual pics looks like it's mounted one spline offset towards left of car so I'm a little unsure.
WillS- I built my steering link using AE ballcups rather then the Yokomo. Same ones I've used for years on B4 and B44. Plenty free on the steering rack and servo saver studs, but not sure if those are a little smaller than the other ballstuds? The cups are a little longer, took about 1mm off the ends so I could get link to 42mm.
Last edited by cjtamu; 05-14-2015 at 08:43 PM.