R/C Tech Forums - View Single Post - TLR TEN-SCTE 2.0 Kit Thread
View Single Post
Old 05-04-2015, 04:45 AM
  #8197  
lowspark
R/C Tech Elite Member
iTrader: (7)
 
lowspark's Avatar
 
Join Date: Oct 2013
Location: Dallas, TX
Posts: 687
Trader Rating: 7 (100%+)
Default

Originally Posted by rcgod
Bump steer is adjusted by flipping the rod ends since they are offset, so on the setup sheet you will see bump up or bump down. That means the offset on the rod end ball is up or down. You can also add washers under the outer ball end.

The set screws in the sway bar mounts are for removing play when running different size bars. They should be just tight enough to remove play, but not hinder sway bar movement.

Shock length is measured eye to eye.

15 deg refers to the angle of the upright in relation to the arm. The 15 deg uprights are more laid back than stock.

rcgod
I wanted to ask about the bump steer setting. You are sayin the direction of the spacer on the ball dertermines bump steer up or down?
Or is it the location of the ball itself that determines this?

On the latest set-up it has it labeled as> Bump Steer: Inside-down, Outer-up.
I read this as the location of the balls. Inside-down means the ball is down (spacer would be up). Outer-up means the ball is up (spacer would be down).

Us old guys get easily confused.... but still fast
lowspark is offline