[QUOTE=justpoet;13975931]The diff shims can be made a little easier with a small chamfer on the corner of the transmition case to help them slide into place [QUOTE]
Thanks, this might have saved me 1h and al lot of fear for damaging the shims. But diffs run perfektly! Inside crown gears seem to be a little heavy.
Bougt new batteries 7500mah (Turnigy Ultimate, 314g).
As a spacer at the rear axle i used 5mm x 0,3mm shims and grinded them to 6mm+ at the inside.
Ordered a scale for 4 weel setup (sky rc), will get it in 14 days to measure every weight of the cars.
I hope to be driving the Tekno on may, 1. (The club is rebuliding the clay-track) Next race (2. and 3. of may) will be on carpet.
This season only a few races are on clay, it is a little bit disapointing here in Germany.