Originally Posted by
sstriano
So the CF with the 3MM spacers is -3? And then the alum. with non is also -3?
The manual shows the CF with 1-1MM and 1-2MM spacer under the stud, so a total of 3MM.
I am a little confused... Should I run the 3MM spacer on the alum. one or no spacers?
Thanks!!
With no spacers the cf =0 and the alloy equals -4mm. Adding spacers to the cf lowers the ball while adding spacers under the alloy raises the ball. If the manual is using 3mm (0-3=-3) with the cf than that would be the same as running 1mm with the alloy (-4+1=-3).