Originally Posted by
Calde315
Buddy was using this nano-tech this past weekend and forgot to pull the balance plug before putting in his truck. Needless to say, it's broken off in the barrel.
What's the easiest way to crack this nano-tech to get at the plug? I just need to fish the remaining bit out and then solder on a new bullet to the charging cable.
I'd like to keep this battery if at all possible. I can't load a picture for some reason, but you can imagine its a smaller bullet that goes in between the power wires to balance the 2s battery out. At least half of the bullet is still in the receptacle.
You can try digging it out with a pick or sharp exacto blade. You can try a drop of sure glue on a paperclip and see if it will stick to the broken piece ( carefull not top put a coating of glue over it). If you want to split the cases, drag a knife around the edges to cut any stickers or seal. then gently pry each half moving around so you don't crack the case.
Good luck.
And you need a minimum amount of posts before you can post picks
