Originally posted by agower
hi,
ive just got the suzuki lightweight input cups to replace the horrible plastic ones. a couple of things though has anyone noticed that they have a bit of play on the inout shaft and actualy move around it when moved with finger? also they seem really noisey when accelrating? can anything be done about this?
also when looking on some setup sheet sfor differnt people i noticed that it says under the roll bar bit:
None
Upper
Lower
____mm
what is the mm bit for and how do i set the length as the one i was lookngi at said 1.6mm in the _____mm section.
thanks
A Gower
Did not like the Suzuki lightweight cups for those same reasons. So went back to the plastic cups. I don't think the Suzuki cups are bad, just didn't like the excess play.
The Roll bars are color coded, you have to measure them with calipers to determin the thickness.
Copper 1.5mm
Brass 1.2mm
Silver 1.1mm
Black 0.9mm