Originally Posted by billdelong

So I'm in the final steps of my build and I've run into 2 issues:

1) The body mounts are roughly 13mm short, I had to back them with 13mm worth of spacers and use a 3x20mm screw to secure them, and now my body fits perfectly.

2) I just put my car on the setup station and the links keep popping off every time I try to adjust the turnbuckles with my wrench. Any ideas on how to fix this? I'm leaning toward boring out the threads on the ball cups, but not sure if someone has tried something else that might be a better solution?

I found that the front upper deck lined up perfectly with my transponder and was able to tap some 3mm threads to mount it fairly easily just in front of the center diff:



I also used a spare ball cup behind the motor to secure my sensor wire: