R/C Tech Forums - View Single Post - Tekno NT48 Thread
Thread: Tekno NT48 Thread
View Single Post
Old 03-11-2015 | 09:59 PM
  #881  
teknorc's Avatar
teknorc
Tech Elite
iTrader: (2)
 
Joined: Jul 2005
Posts: 3,160
From: So Cal
Default
Originally Posted by Tmachine
Just following up on how to prevent from chipping teeth on the spur gear. I run all the braces and tight gear mesh... Any other solutions? I've read in an older post folks are running a differnt brand spur gear? Anyone doing this? Thanks...
Hi guys,
We are testing some new gears now. So far so good. We're doing our best to put this one to bed soon. Thanks.
teknorc is offline  
Reply