Had the dynamite start up set. Was junk I use tools for a living so I know I didnt abuse them. They stripped very easily and damaged plenty of heads. Best bet if you have metric hardware mip makes a set of hex drivers I shopped around got them on Amazon for $30 shipped picked up a 5.5 and 7mm klein nutdriver on Amazon $6 a piece shipped all made in the US tough use the brand for work and Home Depot has a set of needle nose and cutters by crescent/ cooper tools for like $13 all made in usa tough as nails and not to bad price wise you can pick up odds and ends as you go. But I will say cheap tools will cost more in the long run in screws and buying new tools. Good luck!