R/C Tech Forums - View Single Post - Kyosho Inferno GT, GT2 Race Spec
Thread: Kyosho Inferno GT, GT2 Race Spec
View Single Post
Old 03-04-2015, 05:13 PM
  #1188  
sidehow77
Tech Apprentice
iTrader: (2)
 
Join Date: Jan 2012
Location: Perth, Western Australia
Posts: 90
Trader Rating: 2 (100%+)
Default
Originally Posted by MeClown
Hello all

I'm building a custom GT2 using the Carbon Fiber chassis from SNR and components. There is no front kick up so therefore the driveshaft lengths are different. Anyone have any suggestions? Thanks ahead
You need this rear dogbone - http://www.nitrohouse.com/Swingshaft...24_p_3442.html

You can read more about it and the info from SNR on this page...

http://www.rctech.net/forum/electric...gtp2e-114.html

The second link refers to the Ofna Ultra GTP2e, but guys were using the longer SNR chassis to use the Kyosho bodies so explains the conversion process
Hope this helps
sidehow77 is offline  
Reply