Originally Posted by
NuttsnBolts
If you don't mind, can you post up a few pictures showing what the issue is? When I built mine my diff dropped in perfectly and as I mentioned above, I was playing around with diffs during my race meet. Something to check, but have you got all your bulkheads in the correct positions and when you have the X support (B7-302C15) attached to the car, does that sit in it's place properly.
Besides that I can't think of what else it could be with my knowledge as the diff should be a set size from manufacture.
Those bearing shouldn't really be popped out as they are only sold that way. If you need new bearing you just need to buy the corresponding replacement part. Sadly every car over had has been like that. Would shimming the area help?
I wish suspension marks the slope is radial not axial so shimming will not help unfortunately
I mean there must be a way to push them out! Thx Paul