R/C Tech Forums - View Single Post - LOSI XXX-S, Tips and Tricks, Open Mod, etc
Old 02-23-2015, 01:45 PM
  #874  
Johnny Wishbone
Tech Elite
iTrader: (6)
 
Johnny Wishbone's Avatar
 
Join Date: Feb 2006
Posts: 3,756
Trader Rating: 6 (100%+)
Default

Originally Posted by GhostTown
I messed with the low roll center blocks my first week and an half after reading so much about them on this site. Paid all the money and then more off ebay for the MF front and rear blocks. That was the only way my droop screws would even touch the arms. The car never felt right, so I decided to go back to the stock set up from the manual. This helped a lot, but raising the arms back up to high roll center lifted them away from the droop screws. Seems like the only droop I can achieve is about 6.

I'm on a very tight track of around 65/70 x 40. High bite carpet.

There is a set of acer ceramic bearings on ebay for $69. I'm tempted..... but that's a good chunk for something like that.
Why not get longer droop screws, they're just 4/40 grub screws you can get at any hobby shop.
Johnny Wishbone is offline