I'm working on models for my cars. I just finished the new TT02 S-Spec. Can I post the data here or would you rather all the chassis information exchange through the RC3 website?


Also, a suggestion. For high-turn motor classes, getting the low gear ratios can be a problem due to gear size. It would be nice to have chassis parameters for maximum total gear teeth and minimum total gear teeth that mesh. The gearing page could show red values when the pinion or spur are selected that won't fit on the car. Also, there could be a little bar graph that shows the relative motor location when a combination of gears is selected. That way one could select gears without changing the CG if so desired or select a spur that puts the motor in the middle of its adjustment range.