R/C Tech Forums - View Single Post - Palmaris engine thread
View Single Post
Old 02-14-2005 | 07:54 PM
  #1260  
Speedypeterb's Avatar
Speedypeterb
Tech Fanatic
iTrader: (16)
 
Joined: Oct 2002
Posts: 775
From: Pompano Beach FL.
Default thanks

I just wanted to thank Edward and Leo for continueing to make some great p/s sets. We definently had the power which is evident in most of the lap times. We and all that attended just had a hard time keeping all four wheels down on the track. if you were there then you know what we had to deal with and for some of you that weren't on my mtx3, I was running gray springs, 3.5 toe in rear 4degree camber rear 3.5 mm ride hieght, and 57mm 42 shore twister tyres and still could roll it over if you weren't careful. and also we cut the front tires to 21mm width.

we had a great time and many thanks again to Edward and Leo.

hey Richard (Pit-Racer) it was great to meet you and will definently try to come and race with you and Todd.

Go Team Palmaris talk later Peter B.
Speedypeterb is offline