R/C Tech Forums - View Single Post - Tekin RS V1 Issue
Thread: Tekin RS V1 Issue
View Single Post
Old 02-19-2015 | 09:51 AM
  #2  
Jerm13's Avatar
Jerm13
Tech Elite
iTrader: (36)
 
Joined: Feb 2010
Posts: 3,251
From: The 405
Default
Originally Posted by SRC_DRIVER
Having an issue with one of my Tekin RS esc's. When powered up the esc works fine. Throttle input is given through the radio and vehicles moves as it should. However when the wheels stop moving and the vehicles comes to a rest , when the throttle input is given again it will not move. If the vehicle is them bumped or given a push start it takes off fine.

Anyone else have this issue before and know of a fix?

Thanks,
Sounds like a sensor issue. Check to make sure you are not in Dual mode ( sensored and sensorless at the same time) and that the sensor wire is plugged in all the way both on the motor and speedo.

If that all looks good, power everything up and watch to make sure the lights blink as you slowly spin the rear wheels.
Jerm13 is offline  
Reply