Originally posted by berger
I would like to go for a profile with 8 or so across the board then work from there but how much stress is that going to stick on the speedo?
i actually ran a linear 1 with the VFS-2000 with a monster stock (crazy stupid rip).... but i had to cut after every run. i dont know if it has any additional stress. but it will cause more brush/comm wear. and i hope you have good batteries. i wouldnt recommend it for 19T. only stock.
Originally posted by yellow15
Thanks..
is a linear 7 setting still safe to my silver can?
yes it is safe. the 7 setting is a lot higher than the old VFS-2000. watch for wheel spin though. if get wheel spin... might want to lower the first few stages. like this..
9
9
8
8
7
7
.
.
.
.
.7
good luck! if it doesnt rain this sat ill be testing more profile. ill let you guys know.