R/C Tech Forums - View Single Post - Tekno ET48 Build - TP 4070
Thread: Tekno ET48 Build - TP 4070
View Single Post
Old 02-12-2015 | 09:49 PM
  #75  
0verkill's Avatar
0verkill
Tech Master
iTrader: (8)
 
Joined: Oct 2010
Posts: 1,189
From: Birmingham, AL
Default
Originally Posted by WonTonsChicken
Hope that stuff works for ya, however Ive been running these "Novak Double Sided Mounting Tape" with great results.. Just a thought..
That's cool, they use the good stuff (3M VHB). There's several different types.

Originally Posted by Cain
I recall reading some things about spacing issues with the desparado rims, how did you solve them on your build?
I'm actually still running the stock hex wheel hubs. The wheels rubbed on the spindles but it didn't hurt anything.

These are the measurements I took.

Hex - 4.00mm
Dish wheel - 3.90mm
Desperado wheel - 4.80mm

So you would need the +1mm offset lightened hex wheel hub set (TKR5071B). They also make a +2mm offset (TKR5071C).
0verkill is offline  
Reply