R/C Tech Forums - View Single Post - E maxx brushless FLM build!
Thread: E maxx brushless FLM build!
View Single Post
Old 02-09-2015 | 07:05 AM
  #75  
chipmonk
Tech Regular
iTrader: (3)
 
Joined: Dec 2014
Posts: 333
Default
Originally Posted by BuGgYBaShEr.28
Ya good luck. I did that a while back and ended up using a milling machine to get it out. That hardened screw is tough! If its the ones attached to the drive cup then use the updated screws. Part # 99060

Also remember if you use red locktite, in which case I do, be sure to apply heat before removing anything with red locktite. Will keep you from stripping screws. And fine tools also help, cheap Allen's are not the best choice
Thanks for the part #, i ordered 2 sets. I got some good tools from the lhs the other day so it doesnt happen again. It is going to be a pita the get these out.
chipmonk is offline  
Reply