Originally Posted by
kevinpratt823
Xraysupport,
Can you explain to me the issue I have been having where my dog bones bottom out into the drive cups when they go vertical, only allowing half travel when I have the inserts in the inner position?
Also, why does it seem that nobody found this with the 2014 rear hinge plates?
And why does one outdrive protrude father than the other in a diff that was designed to be run either direction?
thanks.
It is suggested to use an o-ring as a back stop on the shock shaft above the collar of the ball joint. With this setting the drive shaft will not get in contact with diff outdrive.
In case the suspension has large uptravel it is suggested to use the outer positions on the suspension holders which will ensure that the drive shafts will not get into contact with diff outdrive.