Made some more progress on my old genX. The battery relocation brackets fit nicely and the new shock mount and beefed up upper pod plate fit well. Installed the long arm setup on the front yesterday, and finished up the esc wiring this afternoon. Unfortunately the output shaft on my little servo is much smaller than I expected, so my servo saver does not fit. I'll either have to order a new servo or a tiny servo saver in order to get this old car on the track. The only servo available locally that will fit is a hitec 225mg which will get it on the track for Wednesday practice, but I've been reading that it isn't a very good servo. Granted, Mt car is old and so are all of the electronics, so it fits the theme...haha