Originally Posted by
rcgod
Sounds like your driving style is a lot like mine. More point and shoot. I want my truck to steer from the front. These worked for me.
Go to the original Dunford setup on Casper.-rc but use the #1 front camber link location. Use #3 pistons with 30/25 or 32.5/27.5 depending on temp and traction. If it still doesn't have enough entry steering go inside on rear camber link on hub. I also like a little drag brake usually about 5 percent. I tried the Losi alum caster blocks and went back to stock ones. The integy blocks are the same geometry as the plastic blocks so you're good there. Truck has tons of entry and mid corner steering and just enough exit steering to not push out. If the traction comes up go to 7k in the center or the truck will diff out under acceleration.
#1 camber link location is for a long front camber link. Did you mean #2? I'm not being a smart*** just trying to clarify.